[Latest Questions] 100% Pass With Best Cisco 300-115 Dumps Real Exam Answers And Youtube Shared

Prepare for Cisco 300-115 exam with the best Cisco CCDP 300-115 dumps real exam practice questions and answers shared from lead4pass. High quality Cisco CCDP 300-115 dumps pdf files and vce youtube demo free update. “Implementing Cisco IP Switched Networks” is the name of Cisco CCDP https://www.leads4pass.com/300-115.html exam dumps which covers all the knowledge points of the real Cisco exam. Latest Cisco CCDP 300-115 dumps exam training materials and study guides free try, pass Cisco 300-115 exam test easily.

The best Cisco 300-115 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VROUdnZWRYLTJta1E

The best Cisco 300-135 dumps pdf questions and answers: https://drive.google.com/open?id=0B_7qiYkH83VRS21DRS14UlZHNjg

Vendor: Cisco
Certifications: CCDP
Exam Name: Implementing Cisco IP Switched Networks
Exam Code: 300-115
Total Questions: 456 Q&As
300-115 dumps
QUESTION 1
An enterprise network has port security sticky enabled on all access ports. A network administrator moves a PC from one office desk to another. After the PC is moved, the network administrator clears the port security on the new network switch port connecting to the PC, but the port keeps going back into errdisabled mode. Which two factors are possible causes of this issue? (Choose two)
A. Port security sticky exists on the new network switch port
B. Port security sticky is disabled on the new network switch port
C. Port security must be disabled on all access ports
D. Port security is still enabled on the older network switch port
E. Port security sticky is still enabled on the older network switch port
Correct Answer: AE

QUESTION 2
Which two statements about SPAN source and destination ports during an active session are true? (Choose two.)
A. The source port can be only an Ethernet physical port.
B. The source port can be monitored in multiple SPAN sessions.
C. The destination port can be destination in multiple SPAN sessions.
D. The destination port does not participate in STP.
E. You can mix individual source ports and source VLANs within a single session.
Correct Answer: BD

QUESTION 3
When a Layer 2 EtherChannel is configured, which statement about placement of the IP address is true?
A. The IP address is placed on the highest numbered member port.
B. The IP address is placed on the port-channel logical interface.
C. The IP address is placed on the lowest numbered member port.
D. The IP address is assigned via DHCP only.
Correct Answer: B

QUESTION 4
300-115 dumps Which VRRP router is responsible for forwarding packets that are sent to the IP addresses of the virtual router?
A. virtual router master
B. virtual router backup
C. virtual router active
D. virtual router standby
Correct Answer: A

QUESTION 5
Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.
DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105
DSW2 – primary device for VLAN 103 and VLAN 104
A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.
Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.
300-115 dumps
What is the priority value of the VLAN 105 HSRP group on DSW2?
A. 50
B. 100
C. 150
D. 200
Correct Answer: B

QUESTION 6
Refer to the exhibit,
300-115 dumps
which statement abort the current configuration on port GigabitEthernet2/0/1 is true?
A. It is an access port configured for a phone and a PC
B. It is a trunk port and the native VLAN is VLAN1
C. It is a trunk port and the natrve VL AN m VLAN 700
D. It is an access port in VLAN 700
Correct Answer: B

QUESTION 7
Enablement of which feature puts the port into err-disabled state when the port has PortFast enabled and it receives BPDUs?
A. BPDU filtering
B. BackboneFast
C. EtherChannel
D. BPDU guard
Correct Answer: D

QUESTION 8
Which database is used to determine the validity of an ARP packet based on a valid IP-to-MAC address binding?
A. DHCP snooping database
B. dynamic ARP database
C. dynamic routing database
D. static ARP database
Correct Answer: A

QUESTION 9
Which will identify the master switch in stack wise? 300-115 dumps
A. lower priority
B. higher priority
C. lower id
D. higher id
Correct Answer: B

QUESTION 10
RSPAN has been configured on a Cisco Catalyst switch; however, traffic is not being replicated to the remote switch. Which type of misconfiguration is a cause?
A. The RSPAN designated VLAN is missing the remote span command.
B. The local and remote RSPAN switches are configured using different session IDs.
C. The local RSPAN switch is replicating only Rx traffic to the remote switch.
D. The local switch is overloaded with the amount of sourced traffic that must be replicated to the remote switch.
Correct Answer: A

QUESTION 11
Refer to the exhibit. Which two commands ensure that DSW1 becomes root bridge for VLAN 10 and 20? (Choose two)
A. spanning-tree mstp 1 priority 0
B. spanning-tree mst 1 root primary
C. spanning-tree mst vlan 10,20 priority root
D. spanning-tree mst 1 priority 4096
E. spanning-tree mst 1 priority 1
F. spanning-tree mstp vlan 10,20 root primary
Correct Answer: BD

QUESTION 12
Which two options are two results of using the command spanning-tree vlan 50 root primary within a spanning-tree network under global configuration? (Choose two.)
A. Spanning tree determines the priority of the current root for VLAN 50 and reduces the priority of the local switch to a lower value.
B. The priority value for VLAN 50 is set to 4094 on the root while the local switch priority is set to 32768.
C. The spanning-tree timers are reduced to improve the convergence time for VLAN 50.
D. All ports that are configured on the current switch with VLAN 50 transition to designated ports.
E. The switchport that is configured for VLAN 50 is the primary connection to the spanning-tree root switch.
Correct Answer: AD

Reference: https://www.leads4pass.com/300-115.html dumps exam questions and answers free update, high quality Cisco CCDP 300-115 dumps exam training materials and study guides shared.

The best Cisco 300-115 dumps vce youtube: https://youtu.be/wyXFLuYtFpI