[Latest Questions] New Cisco CCNP Data Center 300-165 Dumps Exam Real Questions Update Youtube Free Shared

New Cisco CCNP Data Center 300-165 dumps exam real questions and answers free download from lead4pass. High quality Cisco CCNP Data Center 300-165 dumps pdf files and vce youtube demo update free shared. Lead4pass is the best site for providing online preparation material for 300-165 exam. “Implementing Cisco Data Center Infrastructure” is the name of Cisco CCNP Data Center https://www.leads4pass.com/300-165.html exam dumps which covers all the knowledge points of the real Cisco exam. You will also get the 100% guarantee for passing the Cisco exam. Download Cisco CCNP Data Center real 300–165 exam questions and verified answers. 100% passing guarantee and full refund in case of failure.

Vendor: Cisco
Certifications: CCNP Data Center
Exam Name: Implementing Cisco Data Center Infrastructure
Exam Code: 300-165
Total Questions: 187 Q&As

Latest Cisco 300-165 dumps pdf free download from google drive: https://drive.google.com/open?id=0B_7qiYkH83VRS1BVYmN4bjMtcU0

Latest Cisco 300-160 dumps pdf free download from google drive: https://drive.google.com/open?id=0B_7qiYkH83VRaThBc3h5VDkxZEE
300-165 dumps

Cisco CCNP Data Center 300-165 Dumps Exam Real Questions & Answers (1-30)

QUESTION 1
Which two issues explain why a packet is not being routed as desired in a policy-based routing configuration? (Choose two.)
A. The next hop that is configured in the route map has a higher metric than the default next hop.
B. The route map is not applied to the egress interface.
C. The next hop that is configured in the route map is not in the global routing table.
D. The route map is not applied to the ingress interface.
E. The next hop that is configured in the route map has a lower metric than the default next hop.
Correct Answer: CE

QUESTION 2
In policy-based routing, which action is taken for packets that do not match any of the route-map statements?
A. forwarded after the egress queue empties on the outbound interface
B. forwarded using the last statement in the route map
C. forwarded using the closest matching route-map statement
D. forwarded using destination-based routing
Correct Answer: D

QUESTION 3
When you configure LISP, which two components must be configured at the site edge? (Choose two.)
A. AED
B. ELAN
C. ITR
D. EOBC
E. ETR
Correct Answer: CE

QUESTION 4
Which command should you ran to distribute NTP configuration changes by using Cisco Fabric Services?
A. ntp distribute
B. ntp server 1.2.3.4
C. ntp commit
D. ntp authenticate
Correct Answer: A

QUESTION 5
Refer to the exhibit.
300-165 dumps
300-165 dumps
You have a suboptimal outbound routing issue in the datacenter. Which two options you can use to resolve the issue? 300-165 dumps (Choose two)
A. On the OTV VDC, configure an OTV MAC route filter that prevent the virtual FHRP MAC address forwarded on the overlay
B. On the OTV edge devices, configure a VACL that prevents FHRP hellos from being forwarded
C. Configure the same FHRP priority on all the OTV edge devices in both sites
D. Remove the VLAN from which FHRP hellos are sent from the extended VLAN range
E. On the OTV edge devices, configure an IP ACL that prevents hosts from reaching the FHRP master router on the other site
Correct Answer: BD

QUESTION 6
You plan to configure authentication for OSPF. In which mode should you configure OSPF authentication to use a specific key chain?
A. router ospf
B. global configuration
C. vPC
D. interface
Correct Answer: D

QUESTION 7
Which two Nexus family line cards allow the configuration of features regarding LISP, OTV and MPLS? (Choose two.)
A. B1
B. F3
C. F2
D. F1
E. M2
Correct Answer: BC

QUESTION 8
What are two ways to configure the switch ID for Cisco FabricPath? (Choose two.)
A. manually by using the vPC domain configuration
B. manually by using global configuration mode
C. dynamically by using the POAP protocol
D. dynamically by using the DRAP protocol
E. dynamically by using the SNMPv2 protocol
Correct Answer: AB

QUESTION 9
Refer to the exhibit.
300-165 dumps
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Correct Answer: C

QUESTION 10
You have a Cisco Nexus 5000 Series switch. Port security is configured to use sticky learning. Where are the secured MAC addresses stored?
A. the running configuration
B. the startup configuration
C. NVRAM
D. RAM
Correct Answer: C

QUESTION 11
300-165 dumps
300-165 dumps
300-165 dumps
Ethernet interface 1/5 on Cisco Nexus 5548 is connected to Cisco UCS C220 rack server. What is the status of Ethernet 1/5 interface for FCoE functionality?
A. Interface reset on Ethernet 1/5 is preventing the FCoE connection from coming up
B. MTU size of 1500 on Ethernet interface 1/5 needs to be changed for FCoE to come UP
C. Cisco Nexus 5548 needs a layer 3 daughter card for FCoE to come UP on the Ethernet interface 1/5
D. Ethernet interface 1/5 is operational for FCoE and the status is UP
Correct Answer: D

QUESTION 12
Which statement about enhanced zoning on Cisco Multilayer Director Switches are true?
A. It allows partial zone set changes to be distributed without having to activate a zone set.
B. Enhanced zoning is compatible with IVR.
C. Zone changes can scheduled with a CRON job.
D. More than one zone set can be active with enhanced zoning.
Correct Answer: A

QUESTION 13
What are two prerequisite to running the Smart Call Home feature on a Cisco nexus 6000 series switch? 300-165 dumps (Select two)
A. The switch must have SMTP access to an email server
B. The switch must have public management IP address
C. The switch must have SMTP access to a Cisco.com email server
D. The switch must have an active service contract
E. The switch must be configured to use an email address from the @cisco.com
Correct Answer: AD

QUESTION 14
Drag the security description on the left to the appropriate security feature on the right.
Select and Place:
300-165 dumps
Correct Answer:
300-165 dumps

QUESTION 15
Which command sequence correctly enables Adapter FEX on Nexus 5000 Series Switches?
A. switch(config)# install feature-set virtualization
switch(config)# feature-set virtualization
B. switch(config)# install feature-set adapter-fex
switch(config)# feature-set adapter-fex
C. switch(config)# install feature-set adapter-fex
switch(config)# feature-set virtualization
D. switch(config)# install feature-set virtualization
switch(config)# feature-set adapter-fex
Correct Answer: A

QUESTION 16
Refer to the exhibit.
300-165 dumps
This multilayer Cisco Nexus switch had been the active virtual gateway for Group 1 before it became temporarily unavailable. What will happen to GLBP Group 1 when this device becomes available again?
A. The currently active router remains active.
B. It depends on the priority value that is configured active on the router.
C. The Cisco Nexus switch becomes the active virtual gateway after 600 seconds.
D. It depends on the weighting values that are configured active on the router.
Correct Answer: A

QUESTION 17
Which two statements about implementing Cisco NPV and NPIV on a Cisco Nexus 5000 Series switch are true? (Choose two.)
A. STP must run inside the FP network.
B. All VLANs must be in the same mode, CE, or FP.
C. FP port can join the private and nonprivate VLANs.
D. Only F and M series modules can run FabricPath.
E. These require an enhanced Layer 2 license to run.
Correct Answer: BE

QUESTION 18
Which policy-map action performs congestion avoidance?
A. priority
B. bandwidth
C. queue-limit
D. random-detect
Correct Answer: D

QUESTION 19
In OTV, how are the VLANs split when a site has two edge devices?
A. They are configured manually by user.
B. They are split in half among each edge device.
C. They are split as odd and even VLAN IDs on each edge device.
D. It is not possible to have two edge devices in same site.
Correct Answer: C

QUESTION 20
Which protocol is responsible for the discovery of FCoE capabilities on a remote switch?
A. DCE
B. DCBx
C. CDP
D. LLDP
Correct Answer: B

QUESTION 21
Which command enables NPIV on Cisco Nexus 5000 Series Switches and Cisco MDS switches?
A. switch(config)# npiv enable
B. switch(config)# npivon
C. switch(config)# feature npiv
D. switch(config)# npiv proxy
E. switch(config)# np proxy-enable
Correct Answer: C

QUESTION 22
Which statement about core-edge SAN topology is true?
A. Converged FCoE links connect the core and edge MDS switches.
B. The SAN core connects to the network aggregation layer.
C. Separate links with the same I/O are used for SAN and LAN traffic.
D. Storage devices are accessed via FCoE over the LAN network.
Correct Answer: B

QUESTION 23
Which configuration is specific to Cisco TelePresence System seed devices?
A. radius server radius-server-name
B. aaa session-id common
C. radius-server vsa send authentication
D. aaa new-model
Correct Answer: A

QUESTION 24
How does an FCoE end node acquire its FCoE MAC address?
A. server-provided MAC address
B. Fibre Channel name server
C. fabric-provided MAC address
D. FIP proxy
Correct Answer: C

QUESTION 25
Which four options are capabilities of the Cisco Nexus 5000 and 5500 Series Switch? 300-165 dumps (Choose four.)
A. line rate
B. managed by a parent switch
C. lossless 10 Gigabit Ethernet
D. lossless 100 Gigabit Ethernet
E. low latency
F. extremely low latency
G. hosts a virtual supervisor module
Correct Answer: ACEG

QUESTION 26
Which situation must you consider when you add a remote RADIUS server to a Cisco Nexus device?
A. If RADIUS authentication fails, the device falls back to local authentication automatically.
B. If RADIUS authentication fails, the user is denied access with no further authentication checks.
C. If the RADIUS server is unreachable, users are unable to log in.
D. If the RADIUS server is unreachable, all users are given access with the default role.
Correct Answer: B

QUESTION 27
Which two statements about SAN zoning on Cisco Nexus switches are true? (Choose two.)
A. Unlike configured zones, default zone information is not distributed to the other switches in the fabric.
B. Traffic can either be permitted or denied among members of the default zone. This information is not distributed to all switches. It must be configured in each switch.
C. The settings for default zone configurations cannot be changed.
D. To activate a zone set, you must copy the running configuration to the startup configuration after the zone set is configured.
E. Soft zoning restrictions will not prevent a source device from accessing a device outside its zone, if the source knows the Fibre Channel ID of the destination.
F. Hard zoning is enforced by the hardware on each FLOGI sent by an N Port.
Correct Answer: BE

QUESTION 28
Which statement describes what happens if a new EPLD version is released with a new Cisco NX-OS version for a Cisco Nexus switch, but these EPLDs are not upgraded at the same time that NX-OS is upgraded?
A. Any new hardware or software feature that depends on the updated EPLD image is disabled until upgraded.
B. Modules that use an updated EPLD image remain offline until the EPLD is upgraded.
C. The EPLD image version mismatch is detected by the supervisor, which automatically initiates an upgrade.
D. The Cisco NX-OS upgrade fails as a result of the mismatch between EPLDs and NX-OS versions.
Correct Answer: A

QUESTION 29
Which command is used to associate EID-to-RLOC for a LISP site?
A. #feature lisp
B. #ipv6 lisp itr
C. #ip lisp database-mapping
D. #ip lisp itr map-resolver
Correct Answer: C

QUESTION 30
Which feature must be enabled for Cisco TrustSec FC Link Encryption to work on a Cisco MDS 9000 Series Switch?
A. crypto IKE
B. port security
C. LDAP
D. FC-SP
Correct Answer: D

Why Choose Lead4 pass?

High quality IT learning materials offered by the best provider lead4pass. From the following picture, you can see there is a difference between lead4pass and other brands. Other brands started earlier, but the questions are not the latest and it is very expensive. Lead4pass provide the cheapest and newest questions with high pass rate.
300-165 dumps
Practice for your Cisco CCNP Data Center 300-165 dumps exam with the help of lead4pass, at lead4pass you can find all the necessary things for yourself that will help you to pass Cisco 300-165 exam. The best and most updated latest Cisco CCNP Data Center 300-165 dumps pdf training resources which are the best for clearing https://www.leads4pass.com/300-165.html exam test, and to get certified by Cisco CCNP Data Center. Cisco CCNP Data Center 300-165 dumps exam preparation kit contains all the necessary 300-165 questions that you need to know.

The Following Are Some Reviews From Our Customers:

300-165 dumps